Peptide Dosage Calculator
5-Amino-1MQ Dosage Calculator
A free educational 5-Amino-1MQ dosage calculator for research — enter the vial amount and bacteriostatic water volume to get the reconstitution concentration (mg/mL) and syringe-unit reading. Below it, charts convert every 5-Amino-1MQ vial size to mL, cc and U-100 units, and show how much bacteriostatic water each vial takes. Research-use concentration math only; it does not recommend a personal dose, route, or frequency.
Pre-fills example values. Every field remains editable.
The amount printed on the vial or listed on a product page.
Liquid volume used for the concentration calculation.
The mass amount to convert into liquid volume for this math example.
Your result
Syringe-unit reading
200 units
= 2 mL · 50,000 mcg target amount
Concentration
25mg/mL
Per insulin unit
250mcg
Portions per vial
1
Volume
2mL
This calculator is an educational tool for laboratory and research math only. The peptides referenced are research compounds not intended for human or veterinary use, and example values are not medical advice or personal-use instructions. Follow applicable research protocols and regulations.
How the calculator works
Concentration
peptide ÷ liquid
Total peptide divided by liquid volume gives the concentration per mL.
Volume
target ÷ concentration
The target mass divided by concentration gives the liquid volume.
Syringe units
volume × 100
For insulin units, 100 units equals 1 mL, so mL is multiplied by 100.
Reconstituting 5-Amino-1MQ
5-Amino-1MQ is an NNMT-inhibitor compound studied in metabolic research contexts, supplied as a lyophilized powder. Reconstitution is concentration math: the vial amount and the volume of bacteriostatic water you add set the mg/mL concentration. Enter your vial amount and water volume in the calculator above to compute the concentration and syringe-unit reading.
5-Amino-1MQ is supplied in larger research vials (commonly 50 mg or 100 mg) because it is handled at higher amounts than most peptides. Worth knowing before you use the figures below: unlike most compounds here it is also widely sold as an oral capsule, in those same 50 mg and 100 mg strengths, and this calculator applies to the lyophilized vial rather than the capsule. It appears in metabolic research contexts.
5-Amino-1MQ concentration reference
Resulting concentration (mg/mL) for common 5-Amino-1MQ vial sizes at different bacteriostatic water volumes. This is concentration math for interpreting labels — not a dosing table.
| Vial size | + 1 mL water | + 2 mL water | + 3 mL water |
|---|---|---|---|
| 50 mg | 50 mg/mL | 25 mg/mL | 16.67 mg/mL |
| 100 mg | 100 mg/mL | 50 mg/mL | 33.33 mg/mL |
Concentration = vial amount ÷ water volume. Use the calculator above for syringe-unit interpretation. Confirm your actual vial label before reconstituting.
5-Amino-1MQ syringe unit chart (U-100)
A U-100 insulin syringe holds 1 mL across 100 markings, so one unit is always 0.01 mL no matter what is in the vial. That makes the table below a straight conversion between concentration and syringe markings, covering every 5-Amino-1MQ vial size in circulation at each common water volume — it describes what the solution contains, not how much anyone should draw.
| Vial | Water added | Concentration | Per 1 unit | Per 10 units | Full vial |
|---|---|---|---|---|---|
| 50 mg | 1 mL | 50 mg/mL | 0.5 mg | 5 mg | 100 units |
| 50 mg | 2 mL | 25 mg/mL | 0.25 mg | 2.5 mg | 200 units |
| 50 mg | 3 mL | 16.67 mg/mL | 0.17 mg | 1.67 mg | 300 units |
| 100 mg | 1 mL | 100 mg/mL | 1 mg | 10 mg | 100 units |
| 100 mg | 2 mL | 50 mg/mL | 0.5 mg | 5 mg | 200 units |
| 100 mg | 3 mL | 33.33 mg/mL | 0.33 mg | 3.33 mg | 300 units |
One unit = 0.01 mL · amount per unit = concentration × 0.01. Enter your own vial amount and water volume in the calculator above to convert any other combination. This is educational concentration math, not a dosing chart or a personal dose.
Converting 5-Amino-1MQ to mL, cc and syringe units
Three of the units people meet here are the same measurement written three ways. 1 cc = 1 mL = 100 unitson a U-100 syringe, so a figure quoted in cc needs no conversion to mL at all — 0.25 cc is 0.25 mL, which is 25 units. "cc" (cubic centimetre) is the older volume label and still appears on syringe barrels and in a lot of the material circulating about these compounds.
What does need converting is mass to volume, and that is the one step no rule of thumb can shortcut, because it depends entirely on how much bacteriostatic water went into your own vial. Amount ÷ concentration = volume. The table converts amounts across the range a 50 mg 5-Amino-1MQ vial holds, at each water volume.
| Amount | Mixed with 1 mL | Mixed with 2 mL | Mixed with 3 mL |
|---|---|---|---|
| 1 mg | 2 units (0.02 mL) | 4 units (0.04 mL) | 6 units (0.06 mL) |
| 2 mg | 4 units (0.04 mL) | 8 units (0.08 mL) | 12 units (0.12 mL) |
| 5 mg | 10 units (0.1 mL) | 20 units (0.2 mL) | 30 units (0.3 mL) |
| 10 mg | 20 units (0.2 mL) | 40 units (0.4 mL) | 60 units (0.6 mL) |
| 25 mg | 50 units (0.5 mL) | 100 units (1 mL) | 1.5 mL — over one 1 mL syringe |
The amounts are round reference figures spanning roughly a fiftieth to a half of this vial, chosen so the arithmetic stays in range for this vial size. They are reference points for reading a label, not suggested amounts. Where a row reports more than one syringe, the volume simply exceeds the 1 mL a U-100 barrel holds at that concentration.
How much bacteriostatic water to add to a 5-Amino-1MQ vial
There is no correct answer to this in the sense people usually mean — the water volume is a free choice, and it does not change how much 5-Amino-1MQ you have. It changes only how that fixed amount is spread through the solution, and therefore how many syringe markings any given amount occupies. More water means a weaker solution and a larger, easier-to-read volume; less water means a stronger solution and a smaller one.
Two constraints are worth knowing before choosing. A U-100 syringe reads to about half a unit at best, so a volume that lands under roughly 2 units is hard to measure repeatably; and the same barrel stops at 100 units, so a volume over 1 mL cannot be drawn in one go. Water volumes that put your working amount between those two bounds are the practical range. The round-number volumes below are the ones that produce the tidiest concentration figures for each 5-Amino-1MQ vial size.
| Vial | Water | Concentration | Whole vial measures |
|---|---|---|---|
| 50 mg | 1 mL | 50 mg/mL | 100 units (one full syringe) |
| 50 mg | 2 mL | 25 mg/mL | 200 units (2 full syringes) |
| 50 mg | 3 mL | 16.67 mg/mL | 300 units (3 full syringes) |
| 100 mg | 1 mL | 100 mg/mL | 100 units (one full syringe) |
| 100 mg | 2 mL | 50 mg/mL | 200 units (2 full syringes) |
| 100 mg | 3 mL | 33.33 mg/mL | 300 units (3 full syringes) |
Medibact supplies the USP-grade bacteriostatic water used for this step, made at an FDA-registered U.S. facility. For the handling method itself see how to reconstitute peptides, and for the cross-compound view see the peptide reconstitution chart.
Learn more about 5-Amino-1MQ
The Medibact 5-Amino-1MQ Guide covers terminology, research context, and study-summary literacy for 5-Amino-1MQ. Reconstitution uses USP-grade bacteriostatic water; for the general method see how to reconstitute peptides.
FAQ
Is the 5-Amino-1MQ dosage calculator a personal dosing tool?
No. "Dosage calculator" is the common search term, but this is an educational reconstitution and concentration-math tool: it converts vial amount, bacteriostatic water volume, and syringe capacity into concentration (mg/mL) and unit readings. It does not provide a personal dose, route, frequency, or treatment guidance.
How do I reconstitute 5-Amino-1MQ?
Add bacteriostatic water gently down the vial wall and swirl (never shake) until clear. The water volume and the vial amount together set the concentration; the calculator above computes the mg/mL and the syringe-unit reading. This is research concentration math only.
What concentration does a 50 mg 5-Amino-1MQ vial give?
50 mg reconstituted with 1 mL of bacteriostatic water is 50 mg/mL; with 2 mL it is 25 mg/mL; with 3 mL it is 16.67 mg/mL. Enter your actual vial amount and water volume above to see the concentration and per-unit reading.
How many units on an insulin syringe is a 50 mg 5-Amino-1MQ vial?
A U-100 insulin syringe holds 1 mL across 100 units, so one unit is always 0.01 mL. A 50 mg 5-Amino-1MQ vial reconstituted with 1 mL of bacteriostatic water is 50 mg/mL, so each unit contains 0.5 mg and 10 units contain 5 mg; the whole vial is 100 units. Add 2 mL instead and each unit contains 0.25 mg across 200 units. This is a conversion between concentration and syringe markings, not a dose.
How do I convert 5-Amino-1MQ mg to mL?
Divide the amount by the concentration. With a 50 mg vial in 1 mL of bacteriostatic water (50 mg/mL), 1 mg occupies 0.02 mL, which is 2 units on a U-100 syringe. Using more water lowers the concentration, so the same amount occupies proportionally more volume — the unit chart above shows this for each water volume.
How many cc is a 5-Amino-1MQ draw?
1 cc and 1 mL are the same volume, and on a U-100 syringe both equal 100 units — so a figure quoted in cc needs no conversion, only a decimal shift to units. 0.1 cc is 0.1 mL is 10 units; 0.25 cc is 25 units. "cc" is the older label and still appears on syringe barrels. What that volume contains depends on your concentration: at 50 mg/mL (a 50 mg vial in 1 mL), 10 units holds 5 mg.
How much bacteriostatic water should I add to a 50 mg 5-Amino-1MQ vial?
The volume is a free choice and does not change how much 5-Amino-1MQ is in the vial — only how far it is spread, and therefore how many syringe markings a given amount occupies. 1 mL gives 50 mg/mL, 2 mL gives 25 mg/mL, 3 mL gives 16.67 mg/mL. Two practical bounds apply: a U-100 syringe reads to roughly half a unit, so volumes under about 2 units are hard to measure repeatably, and the barrel stops at 100 units, so anything over 1 mL cannot be drawn in one pass.
Does using more bacteriostatic water make 5-Amino-1MQ weaker?
It makes the solution less concentrated, not the vial contents smaller. A 50 mg vial holds 50 mg whether it is dissolved in 1 mL or 3 mL — the same total spread through more liquid, so any given amount is carried in a proportionally larger volume. Doubling the water halves the concentration and doubles the units that the same amount measures as.
Do I recalculate 5-Amino-1MQ if my vial is a different size?
Yes, and this is the most common arithmetic error with these compounds. Concentration is vial amount ÷ water volume, so a unit figure worked out for one vial size is wrong for another even with identical water. 5-Amino-1MQ circulates in 50 mg, 100 mg vials, and the tables above give each one separately. Enter your own label figures in the calculator rather than reusing a number quoted for someone else's vial.
Does Medibact sell 5-Amino-1MQ?
Medibact publishes a 5-Amino-1MQ research guide and supplies the USP-grade bacteriostatic water used to reconstitute lyophilized peptides — it does not sell the peptide itself.
Educational use only — not medical advice. This guide summarizes information reported in published research and community practice for educational purposes. It is not medical advice and not a recommendation to use any compound. Any doses, schedules, or combinations shown are examples of what has been reported, not instructions for you. Many peptides described here are research compounds that are not FDA-approved for the uses discussed and may be investigational or restricted. Effects, risks, and legal status vary; individual needs and results vary. Consult a qualified, licensed healthcare professional before making any decision. Do not use this content to diagnose, treat, or dose yourself.